Flexible Discs for Plaster, Mortar and Screed Machines

Sizes in mm: outer diameter (Ø), bolt circle, bore, width, holes. Torque in Nm. We name a machine only where the fit is confirmed.

• GA000-013 (SGFlex-080.02): Ø 115, bolt circle 80, bore 40, width 22, 6 holes M12, 260 Nm. Fits Putzmeister S5, Utiform V2, Turbosol T20, Euromair CP60 and CP80.
• GN-128-0 (SGFlex-090.03): bolt circle 90, width 26, 6 holes 10. Fits Putzmeister SP 11.
• GA000-029 (SGFlex-096.02): Ø 132, bolt circle 96, bore 46, width 30, 6 holes M12, 420 Nm.
• GAB01-017-0-1 (SGFlex-00096.03): bolt circle 96, width 30, 6 holes 11.2.
• GA000-015 (SGFlex-120.05): Ø 162, bolt circle 120, bore 65, width 30, 6 holes M16, 740 Nm. Fits Putzmeister SP 20 and Brinkmann FHS 200/250 (rear disc).
• GA000-019 (SGFlex-140.05): Ø 195, bolt circle 140, bore 70, width 33, 6 holes M18, 1400 Nm.

No machine listed? Order by part number or dimensions, or ask us.

• Part number: printed on the disc (GA000-..., GAB01-..., GN-... or SGFlex-...). Order by this number.
• Front or rear: some machines use two discs, one on each side of the mixing shaft. The front disc sits at the rotor stator end, the rear disc at the motor end. Check which one you need.
• Dimensions: if the number is unreadable, measure the outer diameter, bolt circle, bore, width, and the number and size of the holes.
• When to replace: when you see cracks or deformation, or notice more vibration or noise during operation.